Sharp PN-HM851 Operation Manual page 45

Function
COMMUNICATION MONITOR CONTROL
SETTING SELECT
BAUD RATE
ID SETTING ID No. SET
ID NO. SETTING (ONCE)
ID NO. SETTING
(SUBSEQUENT)
ID CHECK
ID DISPLAY
AUTO ASSIGN ID No.
REMOTE No.
MONITOR menu
Function
PORTRAIT/LANDSCAPE INSTALL
HORIZONTAL INSTALLATION
ROTATE 180°
OSD H-POSITION
OSD V-POSITION
POWER SAVE MODE
OFF IF NO OPERATION
TIME
POWER ON DELAY
INTERVAL
SELF ADJUST
START TIMING
Controlling the Monitor with a computer (RS-232C)
Command Direction Parameter
CTLS WR 0-2
BAUD WR 0-2
IDST WR 0-255
IDSL W 1-255
0
IDLK W 1-255
0
IDCK W 0 ID
IDLK
IDDP W 0-2
HAID W 1
RCNO WR 0-9
Command Direction Parameter
STDR WR 0-1
MLAY WR 0-1
PFIL WR 0, 3
OSDH WR 0-100
OSDV WR 0-100
STBM WR 0-1
ATOF WR 0-1
AOFT WR 1-12
PODS WR 0-1
PWOD WR 1-60
AADJ WR 0-1
AADD WR 10-200
Reply Control/Response contents
0-2 0: RS-232C, 1: LAN, 2: APPLICATION
0-2 0: 9600bps, 1: 19200bps, 2: 38400bps
0-255 Sets the monitor's ID number. ("0" means "no ID number".)
Set a monitor's ID number to send a command.
This ID number is only effective for the command immediately after this
command.
Clears the ID number if one has been designated.
Set a monitor's ID number to send a command.
This ID number is effective for the next and all subsequent commands after
this command.
Clears the ID number if one has been designated.
: xxx Displays monitor's own ID number and the selected ID number on the screen.
: yyy
0: OFF, 1: ON, 2: ON (turns OFF after 4 sec.)
(The IP address and MAC address are both displayed.)
0-9 Sets the number of the remote control unit.
Reply Control/Response contents
0-1 0: LANDSCAPE, 1: PORTRAIT
0-1 0: OFF, 1: FACE UP
0, 3 0: OFF, 3: ON
"ERR" when PIP MODES is a value other than OFF.
0-100
0-100
0-1 0: OFF, 1: ON
0-1 0: OFF, 1: ON
1-12 1-12: 1-12 hours
0-1 0: OFF, 1: ON
1-60 1-60: 1-60 seconds
0-1 0: OFF, 1: ON
10-200 10: 1 second through 200: 20 seconds
*
●
○
-
○
*
○
45
E