Sharp PN-HM851 Operation Manual page 28

Menu Items
AUDIO OPTION
AUDIO OUTPUT
Sets the volume of sound output from the audio output terminal.
VARIABLE1 ........ You can adjust the volume from the speakers of this monitor and the audio output terminal simultaneously
by using VOLUME.
VARIABLE2 ........ You can adjust the volume from the audio output terminal by using VOLUME.
Sound will not be output from the speakers of this monitor.
FIXED................. Fixes the volume from the audio output terminal. Adjust the volume by using an external device.
AUDIO INPUT LEVEL
Selects the maximum audio input level of the audio input terminal.
MONAURAL AUDIO
Outputs audio signals as monaural.
START INPUT MODE
You can set the input mode that will be in effect when the power is turned on.
When this is set to LAST INPUT MODE, the input mode when the power was last turned off will appear.
* When NO SIGNAL AUTO INPUT SEL. is ON and there is no input signal in the set input mode, the input mode will change
to the input mode that has an input signal.
COMMUNICATION SETTING
MONITOR CONTROL SELECT (when APPLICATION is ENABLE)
RS-232C ............ Select to control this monitor by RS-232C.
LAN .................... Select to control this monitor by LAN.
APPLICATION .... Select to control from the application of APPLICATION mode, such as e-Signage.
BAUD RATE
Selects the communication speed used for RS-232C communication.
ID SETTING
ID No. SET
Assigns ID numbers to monitors connected in a daisy chain (see page 38), using the RS-232 cables.
The numbers 1 to 255 are available for ID numbers.
If "0" is set, the system regards this as the state where no ID number is set.
AUTO ASSIGN ID No.
ID No. to be used will be automatically assigned when multiple monitors are connected with RS-232C.
Select ON, then press the ENTER button.
Perform operations using the first monitor in the daisy chain.
REMOTE No.
Sets the number of the remote control unit. (See page 35.)
nMONITOR
PORTRAIT/LANDSCAPE INSTALL
LANDSCAPE ......Landscape orientation
PORTRAIT .........Portrait orientation
HORIZONTAL INSTALLATION
OFF ....................Portrait/landscape installation.
FACE UP ............The display screen faces up.
ROTATE 180°
If video is upside down when the monitor is installed in portrait orientation, you can rotate the video 180 degrees.
Interlaced signals may not be displayed properly.
OSD H-POSITION
Adjusts the horizontal display position of menu screen.
OSD V-POSITION
Adjusts the vertical display position of menu screen.
28
E