Hardware Installation - EnGenius EnStationACv2 User Manual

Hardware Installation

EnStation5-ACv2/EnStationACv2
1. Remove the rear bottompanel.
2. Connect one end of the Ethernet cable into the main
LAN port (PoE) of the Access Point and the other end to
the AP Ethernet port on the PoE Adapter .
3. Connect the Power cord to the PoE Adapter and plug
the other end in to an electrical outlet.
4. Connect the second Ethernet cable into the LAN port of
the PoE Adapter and the other end to the Ethernet port
on the computer .
5. Place the panel back into device
Note: The EnStationACv2 should ONLY be powered via
Ethernet cableconnectedto includedsupportsbothIEEE
802.3at PoE (Power over Ethernet) or the included PoE
Adapter . You may use either one as the power source.
Do NOT use both at the same time.
Note: TheEnStationACv2cansupplythe 802.3af power
source when used with included PoE Adapter .
Ethernet
Power
Outlet
17
PoEAdapter
PC