Hardware Installation - EnGenius EnStation5-ACv2 User Manual

Hardware Installation

EnStation5-ACv2
1. Remove the rear bottom panel.
2. Connect one end of the Ethernet cable into the main
LAN port (PoE) of the Access Point and the other end to
the AP Ethernet port on the PoE Adapter.
3. Connect the Power cord to the PoE Adapter and plug
the other end in to an electrical outlet.
4. Connect the second Ethernet cable into the LAN port of
the PoE Adapter and the other end to the Ethernet port
on the computer.
5. Place the panel back into device
Note: The EnStation5-ACv2 should ONLY be powered
via Ethernet cable connected to included supports both
IEEE 802.3at PoE (Power over Ethernet) or the included
PoE Adapter. You may use either one as the power
source. Do NOT use both at the same time.
Ethernet
Power
Outlet
17
PoE Adapter
PC