Table of Contents
Advertisement
System Screen
Makes basic settings for the unit.
Board tab
Makes input/output board settings using a setup wizard.
Click the [Setting] button at the bottom of the screen to
start configuration.
For details about settings, see "Setting the System and
Boards" (page 12).
Step 1
Sets the system frequency, input/output mode, and the
number of input/output boards for the unit.
Setup tab
Makes basic operating mode settings of the unit.
System Parameters
Reference Source
Selects the reference signal for operation of the unit. In
NMI mode, only "External HD" and "External SD" can be
selected.
• External HD: Tri-level SYNC signal input on the REF.
INPUT connector
Step 2
Sets the input/output type of ports A to D.
Step 3
Sets the video codec of each port.
Select the codec using the radio buttons.
Step 4
Sets the video signal format of each port.
Select the format to use from the matrix.
Step 5
Select the port grouping to operate in sync.
You can set up multiple combinations of input ports or
output ports.
Step 6
Check the settings made in steps 1 to 5, and submit the
settings.
• External SD: SD signal input on the REF. INPUT
connector
• Input Board A-1, Input Board A-2 to Input Board D-1,
Input Board D-2: Signal input to the HD SDI INPUT
signal on the corresponding board
Preroll Time
Sets the preroll time in units of seconds.
• 0 to 5 to 30 seconds
19
System Screen
- Quick Links:
- Connector Panel
Hide quick links:
Advertisement
Table of Contents
