Sony PWS-4500 Operation Manual page 34

Port information
Displays the operating status of the selected port. The
display is the same as on the Home screen.
Option
Remote 9pin
Selects whether to enable remote control from the device
connected to the REMOTE 1 to 8 connectors.
• Off
• On
Remote 25pin
Selects whether to enable remote control from the device
connected to the GPIO (25-pin) connector.
• Off
• On
Continuous Mode
Sets the preview file or list selection, and the repeat
operation.
• Single File Normal
• Single File Repeat
• File List Normal
• File List Repeat
Feed Play Mode
Sets the playback speed of feed play.
If the playback speed is controlled using the PWA-PRC1
application, this setting is ignored.
• Off (1x)
• On (2x)
• On (4x)
• On (6x)
• On (8x)
• On (16x)
Forced Shuttle Mode
Selects whether to forcibly switch to shuttle control when
using the Jog/Var command.
• Off
• On
Dual Port Effect Mode
Sets whether to execute effect using two playback ports,
when the video codec is set to Avid DNxHD or Apple
ProRes and "HD Multi Output" is selected.
The option is grayed out and is not available for selection
under all other conditions.
• Off
• Resource: Port x
TC Setup
TCR Select
Sets the readout value of the time code reader.
• LTC
• VITC
34
Port Screen
DF Mode
Sets the drop frame mode of the timer counter.
• NDF
• DF
Note
When the frame frequency is not set to 29.97 Hz, the mode
is set to NDF, and DF cannot be selected.
TC OUT
Selects the signal to output from the TIME CODE OUT
connector of the connector panel.
• TC
• Through
• TM1
• TM2
Timer Select
Selects the time data to display.
• TC
• UB
• TM1
• TM2
Timer Set
Displays the time counter.
To change the counter, enter a value and click the [Set]
button. Clicking the [Reset] button resets the counter.
Note
Displayed only when [Timer Select] is set to TM1.
Character
Character On/Off
Selects whether to display superimposed character
information, such as the time code, on the monitor signal.
Character Size
Sets the display size of character information.
• Small
• Medium
Vertical Position
Sets the vertical display position of character information.
• 0 (top) to 22 to 255
Horizontal Position
Sets the horizontal display position of character
information.
• 0 (left) to 128 to 255
Character Info.
Sets the character information content if [Character On/
Off] is set to "On."
• Timedata Only: Timer counter only
• Timedata & VITC: Timer counter and VITC
• Timedata & TM1: Timer counter and TM1