Sony PWS-4500 Operation Manual page 22

PB Tally
Sets whether to add a tally indicator for the monitor signal
from the output port.
• Off
• Auto
Select Mode
Displays the settings of each port configured on the Board
tab.
Automatic Mode
Automatically configures the multi monitor output layout
settings.
Manual Mode
Enables you to configure the multi monitor output layout
settings individually.
The multi monitor screen is divided into four quadrants.
Select the layout of each quadrant. Also, specify the port to
output to each quadrant.
• Layout A: Output the specified port signal to the
quadrant.
• Layout B: Subdivide the quadrant by 2, and output the
specified port signals to the corresponding regions.
• Layout C: Subdivide the quadrant by 4, and output the
specified port signals to the corresponding regions.
"Black" can be selected, in addition to ports, when
specifying the port to output to each region. The region is
displayed solid black when "Black" is selected.
Port Order
When [Automatic Mode] is selected, this specifies the
ordering of ports.
• Vertical
• Horizontal
MONITOR 2 Direction
When [Automatic Mode] is selected, this sets the input/
output direction of the MONITOR 2 connector of the multi
monitor.
• Output
• Input
MONITOR 2 Position
When [Automatic Mode] is selected and the MONITOR 2
connector of the multi monitor is used as an input, this sets
the position on the MONITOR 1 connector output to place
the input video signal.
• Upper Left
• Lower Left
• Upper Right
• Lower Right
When changing the [Multi Monitor] settings, click the
[Submit] button to apply the settings. Click the [Cancel]
button to return to the current settings.
22
System Screen
NMI-Monitor
Stream 1
Sets the output port for NMI Monitor stream 1.
• Port A-1
• Port A-2
Stream 2
Sets the output port for NMI Monitor stream 2.
• Port B-1
• Port B-2
Stream 3
Sets the output port for NMI Monitor stream 3.
• Port C-1
• Port C-2
Stream 4
Sets the output port for NMI Monitor stream 4.
• Port D-1
• Port D-2