Sony PWS-4500 Operation Manual page 8

f GPIO (25-pin) connector
Parallel I/O connector.
For details, refer to the Service Manual or Interface
Manual.
g NETWORK 1 to 2 connectors
Connects to a network cable for monitoring the unit by
SNMP, configuring or checking the unit via HTTP,
transferring files via FTP, etc.
Notes
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port.
Follow the instructions for this port.
• When connecting a network cable, use a shielded-type
cable to prevent malfunction due to radiation noise.
h MAINTENANCE connector
For use by service personnel. Not used for normal
operation.
i NETWORK 3 connector
The unit is equipped with a 10G Ethernet interface board.
Install an SFP+ module and connect to this port using a
network cable.
C Power supply section
a Option slot
Use as one of the following connectors by installing an
option board.
• NMI LAN connector (when PWSK-4506F is installed)
Transfers audio/video stream over an NMI.
• 6G/12G-SDI connector (when PWSK-4508 is installed)
Transfers audio/video stream over 6G-SDI or 12G-SDI.
b AC power supply unit
Connects to an AC power outlet using the power cord.
The unit can be equipped with two power supply units to
provide power supply redundancy. When used in systems
where reliability is required, a second power supply unit
8
Connector Panel
allows the unit to continue operation if one of the supplies
fails.
c U Ground terminal
Connect to ground as required.