Front Panel - Sony PWS-4500 Operation Manual

Names and Functions of
Parts

Front Panel

1 On/Standby button and indicator
4 Network reset switch
a On/Standby button and indicator
Switches the unit on/off (standby state). Connecting the
power cord places the unit in standby state, and the
indicator turns on red. Pressing the On/Standby button
while in standby state turns on the unit and the indicator
turns on green. Pressing and holding the On/Standby
button for two seconds switches the unit to standby state,
and the indicator changes to red. To turn the unit on again
after switching from On state to standby state, when the
indicator is red, press and hold the On/Standby switch for
three seconds or longer. The indicator goes out when the
power cord is disconnected.
b SYSTEM indicator
Displays the status of the unit.
Green: Operating normally
Green (flashing once per second): Starting up
Orange (flashing once per second): Warning message
was issued.
2 SYSTEM indicator
3 ACCESS indicator
Chapter
Red (high-speed flashing four times per second):
Serious error has occurred.
Purple (flashing once per second): Network reset is in
progress.
c ACCESS indicator
Displays the access status of storage.
Off: Not being accessed
Blue: Accessing
Blue (flashing): Formatting or deleting files
d Network reset switch
Resets the IP address and network settings to their default
values. Insert and hold the end of a paper clip or other thin
object into the hole to operate the internal switch and then
start the unit. The SYSTEM indicator will begin flashing
purple.
2
5
Front Panel