JVC CA-UXB70 Service Manual page 9

3.1.2 Removing the front panel assembly
(See Fig.4 ~ 8-2)
• Prior to performing the following procedure, remove the metal
cover.
(1) Disconnect the card wire from connector
com board on the right side of the body.
(2) Disconnect the wire from connector
tor board on the left side of the body and release the wire
from the clamp.
(3) Remove the two screws C on top of the body.
(4) Remove the two screws D on the bottom of the body.
(5) Release the joint a on the bottom and the joint b on each
side of the body using the screwdriver. Remove the front
panel assembly toward the front.
Front panel assembly
Downloaded from www.Manualslib.com
CN700
CN104
Micom board
CN700
Fig.4
Front panel assembly
Regulator board
CN104
Clamp
Fig.5
manuals search engine
on the mi-
on the regula-
C
Front panel assembly
Front panel assembly
Micom board
C
Fig.6
D
Front panel assembly
a
Fig.7
b
Fig.8-1
b
Front panel assembly
Fig.8-2
(No.MB013)1-9
CN700