JVC CA-UXB70 Service Manual page 15

3.1.12 Removing the 5 CD changer mechanism assembly
(See Fig.24 ~ 30)
• Prior to performing the following procedure, remove the metal
cover, the cassette mechanism control board, the cassette
mechanism assembly, the front panel assembly, the rear pan-
el, and the micom board/ regulator board/ heat sink board.
(1) Release the wire extending from the power transformer
from the three clamps in the rear of the main chassis.
(2) Disconnect the card wire from the servo control board in
the CD changer mechanism assembly.
(3) Remove the four screws Q attaching the main chassis on
the right and left sides, and detach the main chassis up-
ward.
(4) Remove the two screws R in the rear of the CD changer
mechanism assembly and remove the two screws S on the
bottom. Remove the CD changer from the bottom chassis.
(5) Remove the two screws T attaching the CD bkt.(F).
(6) Remove the two screws U attaching the CD bkt.(R).
Card wire
Servo control board
CD changer mechanism assembly
Downloaded from www.Manualslib.com
Main chassis
Clamp
Fig.24
Main chassis
Q
Fig.25
manuals search engine
Main chassis
Q
CD changer mechanism assembly
Fig.26
CD changer mechanism assembly
R
Fig.27
Card wire
R
(No.MB013)1-15