JVC CA-UXB70 Service Manual page 14

Micro component system
Hide thumbs Also See for CA-UXB70:
Table of Contents

Advertisement

3.1.10 Removing the power transformer assembly
(See Fig. 21, 22)
• Prior to performing the following procedure, remove the metal
cover, the rear panel, the micom board/ regulator board and
heat sink board.
(1) Release the wire from the three clamps on the main chas-
sis and cut the band.
(2) Remove the four screws O attaching the power transformer
assembly.
Power transformer assembly
3.1.11 Removing the fan
(See Fig.23)
• Prior to performing the following procedure, remove the metal
cover; the rear panel, and the micom board/ regulator board/
heat sink board.
(1) Remove the two screws P attaching the fan.
(2) Release the wire from the clamp.
1-14 (No.MB013)
Downloaded from
www.Manualslib.com
Clamp
Band
Fig.21
manuals search engine
Power transformer assembly
O
O
Fig.22
Clamp
Fig.23
O
O
P
Fan

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sp-uxb70Ux-b70

Table of Contents