JVC CA-UXB70 Service Manual page 34

3.4.4 Removing the head assembly / head board
(See Fig.9 and 10)
• Prior to performing the following procedure, remove the side
bracket (L), (R), cassette hanger assembly / cassette holder.
(1) Remove the spring on the lower side of the head assembly.
(2) Remove the two screws E and remove the head assembly
upward.
(3) Remove the screw F attaching the head board. Unsolder
the flexible wire extending from the head assembly if nec-
essary.
3.4.5 Removing the flywheel assembly (F) and (R)
(See Fig.11 and 12)
• Prior to performing the following procedure, remove the side
bracket (L), (R), cassette hanger assembly / cassette holder.
(1) Remove the belt and sub belt on the bottom of the body.
(2) Remove the polywasher from the flywheel (F) and (R) on
top of the body.
(3) Pull out the flywheel (F) and (R).
1-34 (No.MB013)
Downloaded from www.Manualslib.com manuals search engine
E E
Fig.9
Head board
F
Fig.10
Sub belt
Flywheel assembly(R)
Fig.11
Polywasher
Fig.12
Head assembly
Soldering
Belt
Flywheel assembly(F)
Polywasher