JVC CA-UXB70 Service Manual page 10

3.1.3 Removing the cassette mechanism control board
(See Fig.9)
• Prior to performing the following procedure, remove the metal
cover.
(1) Disconnect the card wire from connector
sette mecha control board.
(2) Remove the two screws E on the left side of the body.
(3) Move the cassette mecha control board upward to release
the joint c.
(4) Disconnect the wire from connector
the cassette mecha control board.
3.1.4 Removing the cassette mechanism assembly
(See Fig.10, 11)
• Prior to performing the following procedure, remove the metal
cover and the cassette mechanism control board.
(1) Disconnect the card wire from connector
com board.
(2) Disconnect the wire from connector on the Motor board in
the rear of the cassette mechanism assembly.
(3) Remove the two screws C and the two screws F on top of
the body.
Move the rear side of the cassette mechanism assembly
upward and remove.
(The chassis bkt. comes off with the cassette mechanism
assembly).
F
C
Front panel assembly
1-10 (No.MB013)
Downloaded from www.Manualslib.com
CN32 on the cas-
CN31 on the inside of
CN791
Cassette mechanism assembly
Micom board
C CN791
Fig.10
manuals search engine
on the mi-
Micom board
F
CN750
Cassette mecha
control board
CN32
c
E
CN31
Fig.9
Cassette mechanism assembly
Motor board
connector
Fig.11
E