JVC CA-UXB70 Service Manual page 32

3.4 Cassette mechanism section
CAUTION:
Prior to performing the following procedures, turn the mode
gear in the direction of the arrow to move each section to the
eject position.
3.4.1 Removing the side bracket (L) and (R) / load board
(See Fig.1 to 4)
(1) Remove the E-washer attaching the load arm on the right
side of the body.
(2) Turn the load arm in the direction of the arrow to release
from the cassette hook at the joint a.
(3) Remove the spring (1) attaching the trig lever.
(4) Move the trig lever in the direction of the arrow and release
it from the two holes b.
(5) Remove the screw A attaching the load board on the right
side of the body and unsolder the wire extending from the
sub motor.
(6) After removing the belt from the sub motor, remove the two
screws B attaching the sub motor.
REFERENCE:
The side bracket unit (R) can be removed even if the load
board is attached. In such case, make sure to unsolder
the wire extending from the sub motor.
(7) Remove the spring (2) and the holder collar on the right
side of the body.
(8) Remove the four screws C attaching the side bracket unit
(R) in the direction of the arrow.
(9) Remove the two screws D attaching the side bracket (L) in
the direction of the arrow.
Joint a
1-32 (No.MB013)
Downloaded from www.Manualslib.com
Loard arm
E washer
Loard arm
Fig.1
Slide bracket
Hole b
Hole b
Spring (1)
Fig.2
manuals search engine
A
Loard board
Fig.3
D
Cassette hanger assembly
D
C
C
Fig.4
B
B
Sub motor
Belt
Soldering
C
C
Holder collar
Spring (2)
Side bracket unit (R)