Entering Memory Channel Contents - Icom IC-9700 Advanced Manual

4. MEMORY OPERATION

Entering memory channel contents

The operating frequency, operating mode, IF filter bandwidth, and so on can be entered to each memory channel.
NOTE: New content you enter will overwrite any
content already in the selected memory.
1. Push to select the VFO mode.
V/M
2. Set the frequency and operating mode.
3. Hold down
kHz
M-CH
4. Rotate to select the Memory channel to
MULTI
enter the contents set in step 2. (Example: 2)
L If "BLANK" is displayed under the selected memory
channel number, it is a blank channel, meaning that
no contents are entered in that channel.
5. Touch the Memory channel number.
6. Touch [MW] for 1 second until BLANK disappears
from below the channel number.
• The contents are entered in the selected Memory
channel, and BLANK is not displayed below the
channel number.
7. To close the VFO/MEMORY screen, push
for 1 second.
"M-CH" is
selected
.
EXIT
4-2