D Repeatedly Transmitting; D Adjusting The Output Level - Icom IC-9700 Advanced Manual

3. VOICE TX MEMORY FUNCTION
Transmitting a Voice memory content

D Repeatedly transmitting

1. Display the VOICE TX screen in a Voice mode.
L(Voice modes: SSB, AM, FM and DV).
» VOICE
MENU
2. Touch the desired Voice memory key [T1] ~ [T8]
for 1 second.
• Repeatedly transmits the recorded content.
Playing time
Information
L
• The recorded content is repeatedly transmitted for
10 minutes, unless you manually stop transmission
by touching the selected memory.
• The Memory Timer counts down.
• " " is displayed while repeatedly transmitting.
• You can set the pause interval between the
repeated transmissions in the "Repeat Time" item
on the VOICE TX SET screen. During this interval,
the transceiver returns to receive. (p. 3-4).
• After 10 minutes have passed, and all of the
recorded content in the memory is transmitted, the
transceiver automatically returns to receive.
• When a signal is received in the interval between
transmissions, the transceiver pauses the next
transmission until the signal disappears. However,
if the squelch is set to open, the transceiver
repeatedly transmits after the repeat interval time
expires, even signals are received.
3. To close the VOICE TX screen, push

D Adjusting the output level

Adjust the Voice TX memory level.
1. Display the VOICE TX screen in a Voice mode.
L(Voice modes: SSB, AM, FM and DV).
MENU
2. Touch [TX LEVEL].
3. Touch any Voice memory key other than [T4] or
[T8]. ([T1] ~ [T3], [T5] ~ [T7])
• The transceiver automatically transmits.
L To adjust the Transmit voice level using [T4] or [T8],
4. While transmitting, rotate
transmit voice level.
L Pushing [DEF] for 1 second returns the value to the
L Adjusting TX LEVEL too high may result in an over
5. To save and close the VOICE TX screen, push
EXIT
.
EXIT
3-3
» VOICE
reverse steps 2 and 3.
default.
modulation and transmit signal distortion.
several times.
to adjust the
MAIN DIAL