Install - Canon D1300 Series Service Manual

COPIER > FUNCTION > SPLMAN
SPL25607 Decrease of paper right and left margins
Details To decrease the margins on the right and left edges of paper.
As the value is incremented by 1, the margin is decreased by 0.1 mm.
If the setting is incompatible with SPL68677 (increase of margins), the
setting is disabled (the margins will be standard).
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 20
Unit 0.1 mm
Default value 0
Related service mode COPIER> FUNCTION> SPLMAN> SPL68677
SPL93822 Setting of department ID count all clear
Details To set whether to disable clearing of all department ID counts.
Adj/set/operate method Enter the setting value, and then press OK key.
Caution Be sure to perform this mode after consulting with the system
administrator at user's site.
Display/adj/set range 0 to 1
0: Enabled, 1: Disabled
Default value 0
Related service mode COPIER> FUNCTION> SPLMAN> SPL78788
SPL78788 Setting of department ID count clear
Details To set whether to disable clearing of department ID count.
Adj/set/operate method Enter the setting value, and then press OK key.
Caution Be sure to perform this mode after consulting with the system
administrator at user's site.
Display/adj/set range 0 to 1
0: Enabled, 1: Disabled
Default value 0
Related service mode COPIER> FUNCTION> SPLMAN> SPL93822
SPL00171 Change of the maximum value of auto sleep shift time
Details To change the maximum value of auto sleep shift time in Settings/
Registration> Timer Settings> Auto Sleep Time.
Use case When changing the setting time to shift to auto sleep mode
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 1
0: 0 to 60, 1: 0 to 240
Default value 0 (For Europe), 1 (For locations other than Europe)
SPL27354 For R&D use
Details For R&D use
Default value Default value is not changed
8
Service Mode > COPIER > FUNCTION > INSTALL
T-8-14
8 Service Mode > COPIER > FUNCTION > INSTALL

■ INSTALL

COPIER > FUNCTION > INSTALL
STRD-POS Scan position auto adj in ADF mode
Details To adjust the ADF scanning position automatically.
Use case At ADF installation/uninstallation
Adj/set/operate method 1) Set a paper for stream reading position adjustment, and then close
the ADF.
2) Select the item, and then press OK key.
The operation automatically stops after the adjustment.
3) Write the value displayed by COPIER>ADJUST>ADJ-XY>STRD-
POS in the service label.
Caution Write the adjusted value in the service label.
Related service mode COPIER> ADJUST> ADJ-XY> STRD-POS
8-16
T-8-15
8-16