Nip-Width Specifications - Canon D1300 Series Service Manual

Nip-width Specifications

The nip-width of the fixing unit is not adjustable in this printer, however the improper nip-width
may cause the poor fixing.
Nip width of the Fixing Assembly can be checked by the following procedure.
1) Select TESTMODE > PRINT > PG-TYPE, and set the value to "2". (Solid black is printed.)
2) Select TESTMODE > PRINT > START, and press the OK key.
3) Turn the printed side of the solid black printed paper down, and place it in the cassette of
the machine.
4) Select TESTMODE > PRINT > PG-TYPE, and set the value to "3". (Blank image is
printed.)
5) Select TESTMODE > PRINT > START, and press the OK key.
6) Open the Front Door immediately before the paper is delivered (when the paper is fed
through the Fixing Assembly), and take out the printed paper after leaving it for 10 seconds
or longer.
• Center (a): 6.1mm to 8.1 mm
• Edge (b) , (c): 6.1mm to 8.1 mm
Media feed direction
6
Trouble Shooting > Trouble Shooting Items > Nip-width Specifications
c
a Center of
A4 sized paper
b
F-6-2
6 Trouble Shooting > Trouble Shooting Items > Nip-width Specifications
6-5
6-5