Fixing System; Removing The Fixing Assembly - Canon D1300 Series Service Manual

4
Disassembly/Assembly > Fixing System > Removing the Fixing Assembly

Fixing System

Removing the Fixing Assembly

Preparations
1) Removing the Left Cover Unit.
2) Removing the Left Rear Cover.
3) Removing the Right Cover Unit.
4) Removing the Rear Cover Unit.
Procedure
CAUTION:
When Removing the Fixing Assembly, Perform the Operation After the Fixing Assembly
is Surely Cooled.
The Fixing Assembly Just After Printing May Cause Burn Injury.
1) Close the Front Cover and Move the Gear In the Position Where It Can Be Removed.
2) Remove the 3 Gears [1].
[1]
4 Disassembly/Assembly > Fixing System > Removing the Fixing Assembly
[1]
F-4-152
CAUTION:
Points to Note at Installation
• Fit the Protrusion [2] of the Gear [1] With the Cut-off of the Gear [3] and Install it.
• Fit the Cut-off [4] of the Gear [1] With the Teeth of the Fan Gear [5] and Install it.
[1]
4-61
[3]
[2]
[1]
[4]
[5]
F-4-153
4-61