Hitron CVE-30360 User Manual page 62

62
The following table describes the labels in this screen.
TABLE 21:
Application Name
Trigger Port Range
Target Port Range
Protocol
Timeout (ms)
Connected Computers
Back
Apply
Cancel
Help
FIREWALL
The Firewall > Port Triggering > Add/Edit Screen
Enter a name for the application for which you want to
create the rule.
NOTE:
Use these fields to specify the trigger ports. When the
CVE-30360 detects activity on any of these ports
originating from a computer on the LAN, it automatically
opens the Target ports in expectation of incoming traffic.
Enter the start port number in the first field, and the end
port number in the second field.
To specify only a single port, enter its number in both
fields.
Use these fields to specify the target ports. The CVE-
30360 opens these ports in expectation of incoming
traffic whenever it detects activity on any of the Trigger
ports. The incoming traffic is forwarded to these ports on
the computer connected to the LAN.
Enter the start port number in the first field, and the end
port number in the second field.
To specify only a single port, enter its number in both
fields.
Use this field to specify whether the CVE-30360 should
activate this trigger when it detects activity via:

Transmission Control Protocol (TCP)

User Datagram Protocol (UDP)

Transmission Control Protocol and User Datagram
Protocol (Both)
NOTE:
Enter the time (in milliseconds) after the CVE-30360
opens the Target ports that it should close them.
Click this to see a list of the computers currently
connected to the CVE-30360 on the LAN.
Click this to return to the Firewall > Forwarding screen
without saving your changes to the port forwarding rule.
Click this to save your changes to the fields in this
screen.
Click this to return the fields in this screen to their last-
saved values without saving your changes.
Click this to see information about the fields in this
screen.
HITRON CVE-30360 USER'S GUIDE
This name is arbitrary, and does not affect
functionality in any way.
If in doubt, leave this field at its default (Both).