Adding Or Editing An Ip Filtering Rule - Hitron CVE-30360 User Manual

54
TABLE 16:
Port Range
Protocol
IP Address Range
Enable
Add New
Edit
Delete
Apply
Cancel
Help
4.4.1

To add a new IP filtering rule, click Add in the Firewall > IP Filtering screen.

To edit an existing IP filtering rule, select the rule's radio button (
Firewall > IP Filtering screen and click the Edit button.
The following screen displays.
FIREWALL
The Firewall > IP Filtering Screen (continued)
This displays the start and end values of the ports to
which communications from the specified IP addresses
is not permitted.
This displays the type of communications that are not
permitted:



This displays the start and end IP address from which
communications to the specified ports are not permitted.
Use this field to turn each IP filtering rule on or off.


Click this to define a new IP filtering rule. See
Editing an IP Filtering Rule
on the screen that displays.
Select an IP filtering rule's radio button (
this to make changes to the rule. See
an IP Filtering Rule
screen that displays.
Select an IP filtering rule's radio button (
this to remove the rule. The deleted rule's information
cannot be retrieved.
Click this to save your changes to the fields in this
screen.
Click this to return the fields in this screen to their last-
saved values without saving your changes.
Click this to see information about the fields in this
screen.

ADDING OR EDITING AN IP FILTERING RULE

HITRON CVE-30360 USER'S GUIDE
TCP displays if communications via the
Transmission Control Protocol are not permitted.
UDP displays if communications via the User
Datagram Protocol are not permitted.
TCP/UDP displays if communications via the
Transmission Control Protocol and the User
Datagram Protocol are not permitted.
Select this checkbox to enable the IP filtering rule.
Deselect this checkbox to disable the IP filtering rule.
on page
Adding or
on page 54 for information
) and click
Adding or Editing
54 for information on the
) and click
) in the