The Ap Screen - ZyXEL Communications AMG1302-T10A User Manual

8.2 The AP Screen

Use this screen to configure the wireless settings of your Device. Click Network > Wireless LAN
to open the AP screen.
Figure 46 Network > Wireless LAN > AP
The following table describes the labels in this screen.
Table 28 Network > Wireless LAN > AP
LABEL
Wireless Setup
Enable Wireless
LAN
Channel
Selection
Common Setup
Network Name
(SSID)
Hide SSID
Security Mode
MAC Filter
Edit
QoS
Apply
AMG1302-T10A User's Guide
DESCRIPTION
Click the check box to activate wireless LAN.
Select the country in which you are using the device. Set the operating frequency/channel.
Select Auto to automatically scan for a channel.
The SSID (Service Set IDentity) identifies the service set with which a wireless device is
associated. Wireless devices associating to the access point (AP) must have the same
SSID. Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless
LAN.
Note: If you are configuring the Device from a computer connected to the wireless LAN and
you change the Device's SSID or WEP settings, you will lose your wireless
connection when you press Apply to confirm. You must then change the wireless
settings of your computer to match the Device's new settings.
Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
See the following sections for more details about this field.
This shows whether the wireless devices with the MAC addresses listed are allowed or
denied to access the Device using this SSID.
Click this to go to the MAC Filter screen to configure MAC filter settings. See
on page 106 for more details.
Select this check box to activate Quality of Service (QoS).
Click this to save your changes.
Chapter 8 Wireless LAN
Section 8.2.6
99