ZyXEL Communications AMG1302-T10A User Manual page 111

Click Network > Wireless LAN > WDS. The following screen displays.
Figure 57 Network > Wireless LAN > WDS
The following table describes the labels in this screen.
Table 39 Network > Wireless LAN > WDS
LABEL
WDS Security
TKIP
AES
#
Active
Remote Bridge
MAC Address
PSK
Apply
Cancel
AMG1302-T10A User's Guide
DESCRIPTION
Select the type of the key used to encrypt data between APs. All the wireless APs
(including the Device) must use the same pre-shared key for data transmission.
The option is available only when you set the security mode to WPA(2) or WPA(2)-
PSK in the Wireless LAN > AP screen.
Select this to use TKIP (Temporal Key Integrity Protocol) encryption.
Select this to use AES (Advanced Encryption Standard) encryption.
This is the index number of the individual WDS link.
Select this to activate the link between the Device and the peer device to which this
entry refers. When you do not select the check box this link is down.
Type the MAC address of the peer device in a valid MAC address format (six hexadecimal
character pairs, for example 12:34:56:78:9a:bc).
Enter a Pre-Shared Key (PSK) from 8 to 63 case-sensitive ASCII characters (including
spaces and symbols).
Click this to save your changes.
Click this to restore your previously saved settings.
Chapter 8 Wireless LAN
111