Table of Contents
Advertisement
•
The length of 1 dot is 0.083 mm (0.0033").
•
You can change the unit to dots or inches in the [System] > [Regional] > [Unit] menu.
•
Set the label size to a value that includes the liner.
[Auto Measure]
The printer automatically measures the length of the media.
The measured length of the media will be automatically saved in [Label Length].
The Auto Measure function can be performed when [Sensor Type] is set to [Gap] or [I-Mark].
The setting procedure of the label length using the Auto Measure function is as follows:
1. Load the media.
2. Enable [Auto Measure].
3. Press the
4. Open the top cover. (Cover Open error occurs.)
5. Close the top cover.
6. When you press the
and measures the label length.
7. The measured label length is saved in [Label Length].
•
When you enable [Auto Measure], this function executes in the following conditions:
◦
◦
◦
•
When [Protocol] in the [Applications] menu is changed to [SZPL], [Auto Measure] is
enabled and executed automatically.
[Speed]
The setting range of the print speed is from 2 to 6 ips (inches/sec) (50.8 to 152.4 mm/sec).
•
When only the optional battery is installed, the setting range is from 2 to 4 ips (50.8 to
101.6 mm/sec).
•
When [Speed] is set to more than 5 ips (127 mm/sec) while the printer is connected to
an AC power supply, it changes to 4 ips (101.6 mm/sec) if the battery starts to be used.
•
Setting the print speed to a level that is too fast may affect the print quality.
/
(Standby/Home) button to show the Home screen.
/
(Standby/Home) button again, the printer feeds two pieces of label
When the printer changes to Online mode for the first time after being powered on
When the printer changes to Online mode after the top cover is opened/closed
When the printer changes to Online mode after the setting of [Sensor Type] is
changed
220
[Speed]
Advertisement
Table of Contents
