Configuring Sta For Ports - SMC Networks TigerStack 100 1000BASE-X Management Manual

Configuring STA for Ports

The following figure and table describe port STA configuration.
Spanning Tree Port Configuration : Unit 1 Port
================================
Fast forwarding on all ports : [Enable]
Port
-----------------------------------------------------
1
2
3
4
5
6
7
8
9
10
11
12
<APPLY> <OK> <CANCEL> <PREV UNIT> <NEXT UNIT> <PREV PAGE> <NEXT PAGE>
Parameter Default
Fast forwarding Enabled
on all ports
Type
Priority 128
Type Priority
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
other keys to make changes.
Description
See "FastForwarding" in this table.
Shows port type as:
100FX
1000SX
1000LX
1000T
Defines the priority for the use of a port in the STA
algorithm. If the path cost for all ports on a switch are
the same, the port with the highest priority (i.e., lowest
value) will be configured as an active link in the
Spanning Tree. Where more than one port is assigned
the highest priority, the port with lowest numeric
identifier will be enabled. The range is 0 - 255.
C
ONFIGURING THE
Cost FastForwarding
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
: 100BASE-FX
: 1000BASE-SX
: 1000BASE-LX
: 1000BASE-T
S
WITCH
1 - 12
[Disable]
2-37