Switchport Broadcast Packet-Rate; Clear Counters - SMC Networks 100BASE-TX Management Manual

4
Command Line Interface

switchport broadcast packet-rate

This command configures broadcast storm control. Use the no form to disable
broadcast storm control.
Syntax
switchport broadcast octet-rate rate
no switchport broadcast
rate - Threshold level as a rate; i.e., octets per second.
(Range: 64-95232000)
Default Setting
Enabled for all ports
Packet-rate limit: 32000 octets per second
Command Mode
Interface Configuration (Ethernet)
Command Usage
• When broadcast traffic exceeds the specified threshold, octets above that
threshold are dropped.
• This command can enable or disable broadcast storm control for the selected
interface. However, the specified threshold value applies to all ports on the
switch.
Example
The following shows how to configure broadcast storm control at 600 octets per
second:
Console(config)#interface ethernet 1/5
Console(config-if)#switchport broadcast octet-rate 600
Console(config-if)#

clear counters

This command clears statistics on an interface.
Syntax
clear counters interface
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-4)
Default Setting
None
4-110