Dot1X Timeout Tx-Period; Show Dot1X - SMC Networks 100BASE-TX Management Manual

4
Command Line Interface

dot1x timeout tx-period

This command sets the time that the switch waits during an authentication session
before re-transmitting an EAP packet. Use the no form to reset to the default value.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout tx-period 300
Console(config-if)#

show dot1x

This command shows general port authentication related settings on the switch or a
specific interface.
Syntax
show dot1x [statistics] [interface interface]
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
Command Mode
Privileged Exec
Command Usage
This command displays the following information:
• Global 802.1X Parameters – Shows whether or not 802.1x port
authentication is globally enabled on the switch.
• 802.1X Port Summary – Displays the port access control parameters for
each interface, including the following items:
- Status
- Operation Mode
- Mode
- Authorized
4-82
– Administrative state for port access control.
– Dot1x port control operation mode (page 4-79).
– Dot1x port control mode (page 4-79).
– Authorization status (yes or n/a - not authorized).