Figure 3-14. Enabling Telnet - SMC Networks 100BASE-TX Management Manual

3
Configuring the Switch
• Password Threshold – Sets the password intrusion threshold, which limits the
number of failed logon attempts. When the logon attempt threshold is reached, the
system interface becomes silent for a specified amount of time (set by the Silent
Time parameter) before allowing the next logon attempt.
(Range: 0-120; Default: 3 attempts)
• Password* – Specifies a password for the line connection. When a connection is
started on a line with password protection, the system prompts for the password.
If you enter the correct password, the system shows a prompt. (Default: No
password)
• Login* – Enables password checking at login. You can select authentication by a
single global password as configured for the Password parameter, or by
passwords set up for specific user-name accounts (the default).
* CLI only.
Web – Click System, Line, Telnet. Specify the connection parameters for Telnet
access, then click Apply.
3-22

Figure 3-14. Enabling Telnet