Figure 3-47. Enabling Port Broadcast Control - SMC Networks 100BASE-TX Management Manual

3
Configuring the Switch
Web – Click Port, Port/Trunk Broadcast Control. Set the threshold, mark the
Enabled field for the desired interface and click Apply.
CLI – Specify any interface, and then enter the threshold. The following disables
broadcast storm control for port 1, and then sets broadcast suppression at 600
octets per second for port 2.
Console(config)#interface ethernet 1/1
Console(config-if)#no switchport broadcast
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#switchport broadcast octet-rate 600
Console(config-if)#end
Console#show interfaces switchport ethernet 1/2
Information of Eth 1/2
Broadcast threshold:
Lacp status:
Ingress rate limit: disable, Level: 30
Egress rate limit: disable, Level: 30
VLAN membership mode:
Ingress rule:
Acceptable frame type:
Native VLAN:
Priority for untagged traffic: 0
Gvrp status:
Allowed Vlan:
Forbidden Vlan:
Private-VLAN mode:
Private-VLAN host-association: NONE
Private-VLAN mapping:
Console#
3-78

Figure 3-47. Enabling Port Broadcast Control

Enabled, 600 octets/second
Enabled
Hybrid
Disabled
All frames
1
Disabled
1(u),
NONE
NONE
4-104
4-110
4-110
4-113