Enabling Radius Globally; Adding Radius Server For Authentication - Avaya VSP 4000 Technical Configuration Manual

4.1 Enabling RADIUS globally

To use RADIUS, it must be enabled globally using the following command.
VSPswitch:1(config)#radius enable
If you wish specify and use the source IP address for the RADIUS server configuration, you must also
enable the global parameter using the following command
VSPswitch:1(config)#radius sourceip-flag

4.2 Adding RADIUS server for authentication

To add a RADIUS server, enter the following command with the option of enabling accounting and
specifying the source IP address. If you do not specify the source IP, the VSP switch will use the source
IP address of the out-going interface. Depending on the number of out-going interfaces, you may have to
add two or more RADIUS authenticators on your RADIUS server unless you specify the source IP
address. The source IP address should be a circuitless/loopback IP address which is not tied down to a
physical interface.
VSPswitch:1(config)#radius server host <ip address> key <secret key> ?
acct-enable Server acct enabled
acct-port Server acct udp port
enable Server enabled
port Server udp port
priority Server priority
retry Max number of retries
source-ip Source ip address
timeout No answer timeout value
used-by Use for cli,eapol,snmp or web
<cr>
March 2015
Avaya Inc. – External Distribution
avaya.com
26