8.2 Blocking SNMP
By default, SNMP access is enabled. You can disable SNMP; this includes SNMPv1/v2 and SNMPv3,
access to the VSP switch by using the following commands:
VSPswitch(config)#boot config flags block-snmp
VSPswitch(config)#save boot
To re-enable SNMP access, type in the following command:
VSPswitch(config)#no boot config flags block-snmp
8.3 Blocking SNMPv1/2 only
If you wish to allow only SNMPv3 access, you can disable SNMPv1/2 only by entering the following
commands:
To disable SNMPv1/v2 only, enter the following commands:
VSPswitch(config)#no snmp-server community-by-index first
VSPswitch(config)#no snmp-server community-by-index second
At this point, SNMPv1/v2 will be disabled and only SNMPv3 will be allowed.
March 2015
Avaya Inc. – External Distribution
avaya.com
102