Access Policies And Snmp - Avaya VSP 4000 Technical Configuration Manual

9.3 Access Policies and SNMP

A policy can be added to allow an administrator to specify a group or groups from the View-based Access
Control Module (VACM) for SNMPv1, SNMPv2c, or USM. This allows the administrator to create separate
policies for SNMP users based on USM (SNMPv3) or community (SNMPv1 or SNMPv2c) and associate
them to groups.
The following command is used to add a SNMP group to a policy.
VSPswitch(config)#access-policy <1-65535> snmp-group <group name> <
snmpv1|snmpv2c|usm>
VSPswitch(config)#access-policy <1-65535> snmpv3
In regards to the SNMP group name, use the following command to display the SNMP VACM group
access configuration. The default SNMPv1 and SNMPv2c read group name is readgrp while the default
read-write group is v1v2grp which can be found under the snmpv1 and snmpv2c VACM model as shown
below. All SNMPv3 groups are shown under the USM model. Please refer to the SNMPv3 section above
for more details.
VSPswitch#show snmp-server group
================================================================================
================================================================================
Group Prefix Model
group_1 usm
|
readgrp snmpv1
readgrp snmpv2c noAuthNoPriv v1v2only
|
v1v2grp snmpv1
v1v2grp snmpv2c noAuthNoPriv v1v2only
March 2015
VACM Group Access Configuration
Level ReadV
authPriv org
noAuthNoPriv v1v2only
noAuthNoPriv v1v2only
Avaya Inc. – External Distribution
WriteV NotifyV
org
org
org
v1v2only v1v2only
v1v2only v1v2only
avaya.com
126