Roland VersaUV LEJ-640 F User Manual page 12

Part Names and Functions
1
DOWNLOAD When the printing job is completed, the unit will place itself in the position of pick up of the printed material.
SEQUENCE It gives the possibility to work continuously.
RETURN At the end of the work the unit will place itself at the starting point, ready to start a new printing cycle.
STRATIFY It is used to simulate a 3D kind of printing, where the printing action is repeated as many times as it is wished.
Indicates the vacuum zone which you wish to enable.
When pushed it is used to reset the axes.
When pushed it allows the table aspiration.
Indicates the height from the head to point 0 of the plane.
Indicates the longitudinal position of the printing unit.
When pushed it allows to switch on the laser pointer.
It indicates that the laser pointer is switched on.
When pushed it allows to set the height manually measured of the material to be printed.
When pushed it allows to select the printing mode.
When pushed it allows to select the start of the printing cycle.
When pushed it allows to con rm the height of the measured material.
When pushed it allows to disable the selected function.
When pushed it con rms the selected function.
It indicates that the data are protected by the password, actions limited to technical personnel.
When pushed it allows to move from one screen page to the other.
When pushed it allows to move from one screen page to the other.
General Switch
General Switch
- In vertical position "ON" it
feeds the electric line.
- When turned to the left (in
position "OFF") disconnects all
the electric line.
10
Key of the General Electric
Panel
Key provided only and exclusively
to the responsible of the electric
installation who should keep it
always with him.
It is absolutely forbidden to
unauthorized personnel to open
the electrical panel.
For more security the key doesn't
open the panel if the general swi-
tch is not in the "OFF" position.