Roland VersaUV LEJ-640 F User Manual page 112

An Error Message Appears
[TEMPERATURE IS TOO LOW **°C]
The temperature of the location where the machine is installed has fallen below the ambient
temperature at which the machine can operate.
Operation cannot be continued. Switch o the sub power. The displayed temperature is the current ambient
temperature of the installation location. Bring the installed location to a temperature at which operation is
possible (20 to 32°C) and allow the machine to come to room temperature, then turn on the power.
[DATA ERROR CANCELING...]
Output was stopped because a problem was found in the data received.
Operation cannot be continued. Check whether the data contains errors. Also, check for a problem with the
connector cable or the computer, and redo the operation from the step of loading the media.
[WRONG CARTRIDGE]
A cartridge that cannot be used was installed.
Remove the cartridge to clear the error. Use a cartridge of the speci ed type.
[WRONG HEAD IS INSTALLED]
An unusable print head is installed.
Switch o the sub power. After you switch o the power, inform your authorized Roland DG Corp. dealer.
[AVOIDING DRY-UP TURN POWER OFF]
The print heads were forced to standby position to prevent them from drying out.
Operation cannot be continued. Switch the sub power o , then back on. Opening the front cover while output
is in progress causes an emergency stop. Never allow the print heads to remain in this state.
[MOTOR ERROR TURN POWER OFF]
A motor error occurred.
Operation cannot be continued. Switch o the sub power. Next, eliminate the cause of the error, then im-
mediately switch on the sub power. If the machine is allowed to stand with the error uncorrected, the print
heads may dry out and become damaged. This error may be caused by such factors as a mistake in loading
the media, a media jam, or an operation that pulls the media with excessive force.
[CANCELED FOR MOTOR PROTECTION]
Continuous operation made the pump motor become hot, and so operation was paused.
Press any key to clear the error. Allow the machine to stand for approximately 40 minutes before resuming
6
operation.
110