Samsung SNP-6321H Network Setup Manual page 44

setup screen
SNMP
With the SNMP protocols, the system or network admin can monitor the network devices on a remote site, and
configure the environment settings.
1. From the Setup menu, select the <Network (
2. Click <SNMP>.
3. Specify the <SNMP>.
• Enable SNMP v1 : SNMP version 1 will be active.
• Enable SNMP v2c : SNMP version 2 will be active.
- Read community : Provide the name of the read
community where you can access to the SNMP
information.
The default name is <public>.
- Write community : Provide the name of the write community where you can access to the SNMP
information. The default name is <write>.
• Enable SNMP Trap : SNMP trap is used to send important events and conditions to the Admin.
- Community : Enter the trap community name to receive messages.
- IP address : Enter the IP address to which messages will be sent.
- Authentication failure : It specifies whether an event shall be generated when the community information
is invalid.
- Network connection : It specifies whether an event shall be generated when the network disconnection
is restored.
• Enable SNMP v3 : SNMP version 3 will be active.
- Password : Specify the default password for SNMP version 3. The default password is <admin4321>.

The default password can be exposed to a hacking thread so it is recommended to change the password after installing the
product.
Note that the security and other related issues caused by the unchanged password shall be responsible for the user.

Password should be longer than 8 characters, no more than 16 characters.
4. When done, click [Apply (

J
SNMP v3 is only able to be set when the secure connection mode is HTTPS.
Refer to "SSL". (page 42)

If you don't use SNMP v3, there may be a security issue.
44_ setup screen
)> tab.
)].