Samsung SNP-6321H Network Setup Manual page 43

802.1x
When connecting network, you can choose whether using 802.1x protocol, and then install the certification.
1. From the Setup menu, select the <Network (
2. Click <802.1x>.
3. Set the <IEEE 802.1x setting(EAPOL using EAP-TLS)>.
• Enable IEEE 802.1x : Specify the use of the 802.1x
protocol.
• EAPOL version : Select version 1 or 2.
• ID : Enter the client certificate ID.
• Password : Enter the client private key password. If the
key file used is not encrypted, you don't need to enter it.

J
If the connected network device does not support the 802.1x protocol, the protocol will not operate properly even if
you set it.
4. Install/remove the certificate.
• CA certificates : Select a public certificate that contains the public key.
• Client certificate : Select a public certificate that contains the client certificate key.
• Client private key : Select a public certificate that contains the client private key.
5. When done, click [Apply (
To install/remove 802.1x related certificates
1. Press the [Browse (
2. If no certificate is installed, you will see "Not Available" appearing next to the selected item.
3. Press the [Install (
4. Press the [Delete (
QoS
You can specify the priority to secure a stable transfer rate for a specific IP.
1. From the Setup menu, select the <Network (
2. Click <QoS>.
3. Click the [Add ( )] button.
The IP list will be created.
4. Enter an IP address to which you will apply QoS.
M 
The default prefix for IPv4 is 32;
For DSCP, the default is set to 63.

Only the IP addresses that are set to <Use> can be prioritized.
5. Select an IP to delete from the list.
Click the [Delete (
6. When done, click [Apply (
)> tab.
)].
)] button for each item and select a certificate to install.
)] button to start installation with a message of "Installed" next to the item.
)] button to remove the certificate.
)> tab.
)] button.
)].
English _43