Configuring Ip Installer Values - Samsung SNP-6321H Network Setup Manual

Item
Auto Set
Manual Set
Exit

CONFIGURING IP INSTALLER VALUES

How to configure with a static IP
Notice for Setup with a Static IP
If assigning a static IP to the network camera: If the range of the assigned static IP is close to that of
network devices (such as PC and printer to which IP addresses are assigned), it may cause an IP
assignment error or an IP collision with other network devices after the router is turned off/on or reset. For
this reason, it is recommended to assign IP addresses that are not usually used in other network devices.
Ex) If network devices such as printer and PC use between 192.168.1.1 and 192.168.1.10 in the router:
The network camera should use between 192.168.1.101 and 192.168.1.200.
How to configure IP manually using [Manual Set]:
1. Launch the IP Installer on the PC for IP configuration.
2. Click the [Search] button. A list of network devices using IP
addresses located at the same router is displayed.
3. Check the MAC address information and select a device to
configure.
4. Click the [Manual Set] button. A window to configure an
address and port pops up.
5. Enter the IP range information assigned by the network
administrator or the IP range information (IP Address,
Subnet Mask, Gateway, HTTP Port, Device Port) that you
want to assign.
6. Type the password authentication number for camera
access and click the [OK] button. Configuration is now
complete.
The IP Installer automatically configures the network settings.
You should configure the network settings manually.
Exits the IP Installer program.
Description
English _19