Samsung SNP-6321H Network Setup Manual page 21

Hide thumbs Also See for SNP-6321H:

Table of Contents

Notice for Installer Setup

1. If two or more network cameras are connected to the router, you should configure the IP and port-

related parts differently.

IP related settings

Port related settings

2. If the <HTTP Port> is set other than 80, you must provide the <Port> number in the address bar of

the Internet browser before you can access the camera

ex) http://IP address : HTTP Port  http://192.168.1.100:8080)

How to configure with a dynamic IP

Notice for Setup with a Dynamic IP

A dynamic IP allows you to use IP address resources effectively. It is needed when assigning an IP address

using a DHCP server in a LAN environment, when assigning an IP address using a DHCP of a router in a

local network, or when connecting a network camera to a modem that supports DHCP.



If the network camera is set to use a dynamic IP, the monitoring PC program in the local network environment or

in an external remote location may not detect the network camera. This is because IP and port may be changed

when the router power is reset or recovered from a failure.

To solve such problems, it is recommended to set up the port forwarding in the higher router layer.

Refer to "How to configure port forwarding" to learn more about how to configure port forwarding. (Page 23)

Table of Contents