Samsung SNP-6321H Network Setup Manual page 20

network configuration
M 
The password for camera access is identical to the "admin" login password.
Default value is "4321".

In the IP installer, you can use the initial password, "4321" to set IP Address, Subnet Mask, Gateway, HTTP Port,
Device Port, IP type. After changing the network interface, for better security, access the web viewer and change the
password.

For the security purposes, you are recommended to use a combination of numbers, alphabets uppercase and
lowercase and special characters for your password.

HTTP Port is used to connect to the camera using web browser.
Default value is "80".

Device Port is to control video transmission.
Default value is "4520".
How to configure an IP address automatically using [Auto Set]:
1. Launch the IP Installer on the PC for IP configuration.
2. Click the [Search] button. A list of network devices using IP
addresses located at the same router is displayed.
3. Check the MAC address information and select a device to
configure.
4. Click on the [Auto Set] button.
[Auto Setting] window with IP Address, Subnet Mask and
Gateway entered pops up.
5. Type the password authentication number for camera
access and click the [OK] button. Configuration is now
complete.
M 
The password for camera access is identical to the "admin"
login password.
Default value is "4321".

In the IP installer, you can use the initial password, "4321" to
set IP Address, Subnet Mask, Gateway, HTTP Port, Device Port,
IP type. After changing the network interface, for better security,
access the web viewer and change the password.

For the security purposes, you are recommended to use a combination of numbers, alphabets uppercase and
lowercase and special characters for your password.

Device Port is to control video transmission.
Default value is "4520".
20_ network configuration