Schwinn 411 Service Manual page 46

14. Hold the lower end of the old I/O Cable and carefully pull it down
through the Console Mast. Untie the string from the old I/O Cable and
discard the old I/O Cable.
15. Connect the new I/O Cable to the piece of string or wire.
Note: Do not crimp the Cables.
16. Hold the upper end of the string and carefully pull the new I/O Cable
through the Console Mast.
Note: Do not crimp the cables.
17. With the new I/O Cable routed through the Console Mast, reconnect
the Cables to the Frame Assembly, and then re-attach the Console Mast
without crimping the Cables.
18. Untie the string from the new I/O Cable.
Note: Do not crimp the Cables.
19. Connect the new I/O Cable and HR Cable to the Console, and attach
it to the Console Mast.
Note: Do not crimp the Cables.
20. Re-assemble the machine in the reverse order of when the parts
were removed.
21. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
46