Schwinn 411 Service Manual page 44

6. Using two 6mm hex wrenches, remove the indicated hardware (by
arrows) that attaches the Handlebar Assemblies to the Frame Assembly
and Pedal Arms.
Be aware that the Handlebar Assembly will be loose and will
pivot when the hardware is removed. Safely allow the Handle-
bar Assembly to pivot downward and come to rest. Be sure
not to be in the path of the Handlebar Assembly.
7. Carefully remove the Handlebar Assemblies from the Frame Assembly
and place outside the work area.
8. Using a 6mm hex wrench, remove the 6 sets of hardware (indicated by
oval) from the Console Mast.
9. Slightly lift the Console Mast from the Frame Assembly and disconnect
the Cables. Fully remove the Console Mast with the Cables.
Note: Do not crimp the Cables. Do not allow the Cables to be pulled into
the Console Mast.
44
Console Mast
Handlebar
Assemblies
Pedal Arm
Console Mast