Advertisement
VHU Series Humidified and Heated Holding Cabinets
Verify that the power source matches
the Serial Data Plate located toward
the back of the cabinet and the plug
configuration before the connection is
made.
(Fig. 3)
The Cabinet and its parts are hot. Be very careful when operating, cleaning,
or servicing the cabinet. Heating elements are located at the bottom of the unit, and
touching the floor of the internal cavity or water pan can result in injury.
Basics
Instructions:
1. Turn unit on.
2. Select temperature. Humidity will
automatically adjust.
Optional
Select alternative humidity setting.
To deactivate humidity, press knob for 5
seconds.
Press knobs for internal temperature or
humidity.
Detailed Explanation
A lighted switch allows you to turn the cabinet
ON/OFF (cabinet is ON when the switch is
illuminated).
The VHU cabinet allows control of both
temperature and humidity. There are 2
displays and 2 knobs; the set on the left is for
temperature and the set on the right is for
humidity. Changing the temperature will
automatically adjust the humidity. Always
choose your desired temperature first, and if
needed, fine-tune humidity.
humidity is designed to hold moist foods.
OPERATION INSTRUCTIONS
The preset
6
(Fig. 3) – only an example, not representative of
all units
To operate the cabinet with humidity, the
internal water pan must be filled. The max
capacity of the water pan is 2 U.S. gallons or
7.5 liters. The internal water pan should be
filled periodically, approximately every 3
hours during high volume use. Water drips
into a secondary pan underneath the unit.
This pan of water should be emptied each
time the internal water pan is filled.
The cabinet
can
humidity control. Press and hold down the
humidity knob for 5 seconds to deactivate.
The right display will go blank once humidity
control is deactivated. To reactivate press
the humidity knob. For best operation while
holding dry foods (such as fried chicken and
French fries) remove water from internal
humidity pan.
The display shows the desired temperature
or humidity. To see the current internal
temperature
or
humidity,
appropriate knob. The internal temperature
will be displayed for 4 seconds – if the
internal temperature or humidity is the same
as the desired it will appear that the display
does not change.
Effective 03-16
be operated
without
press
the
Advertisement
