Figure 2-48 Connecting Battery Cable; Ip4Ww-Battery Box Fuse Replacement - NEC SL2100 Hardware Manual

SL2100
2. Cut and remove Plastic Knockout from the Sub-Cover to connect Battery cable.
For your safety, smooth the cut edges after removing the plastic knockout.
Plastic
Knockout
Battery cable
3. Connect Battery cable from the Battery box to Battery connector on the Chassis.

2.8 IP4WW-Battery Box Fuse Replacement

• In the event of a blown fuse correct the fault causing the fuse to blow before
replacing the fuse; otherwise you may cause fire or electrical hazards.
• Be sure to use only the specified fuse (250V T8AL).
• Be sure to install the fuse into the correct location.
• Be careful not to burn yourself on the heated fuse. The blown fuse may be
heated soon after blowing.
• If Expansion Chassis are installed, turn the power on/off in the order of
Expansion 2 Chassis, Expansion 1 Chassis and then Main Chassis.
1. Power off the Chassis and disconnect AC cord.
2-36
Cut

Figure 2-48 Connecting Battery Cable

ISSUE 1.0
Installation