Table 2-20 Switch Setting Of 2Bridb-C1 - NEC SL2100 Hardware Manual

SL2100
1. Set the switches J12 to J17 according to the system, referring the
2BRIDB-C1 on page
Switch No.
J12/J15
J13, J14/J16, J17
J12 & J15 do not configure the connection type on the system, they only add/remove the termination
of the circuit.
J13,J14 & J16, J17 do not configure the connection type on the system, they only select the polarity of
the connector J2/J3.
The 2BRIDB-C1 circuits must also be setup within the system configuration.
2-54
2-54.

Table 2-20 Switch Setting of 2BRIDB-C1

Switch Position
ON (default) Termination register is ON.
This SW should be ON in case:
• T-Bus Point-to-Point connection is selected.
• T-Bus Point-to-Multipoint is selected, and if the system is Terminal 8.
(last device on the bus)
• S-Bus.
OFF P-MP (Terminal 7)
T (default) T-Bus connection
S S-Bus connection
Table 2-20 Switch Setting of
Description
ISSUE 1.0
Installation