Commissioning - Biasi Riva Advance Combi Installation & Operation Instructions

15. Commissioning

FOR YOUR SAFETY READ BEFORE OPERATING
WARNING
A This appliance does not have a pilot. It is
equipped with an ignition device which
automatically lights the burner. Do not try to
light the burner by hand.
B BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next
WHAT TO DO IF YOU SMELL GAS
--- Do not try to light any appliance.
--- Do not touch any electric switch; do not use
any phone in your building.
--- Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
1. STOP! Read the safety information above on
this label.
3. Set the thermostat to lowest setting.
4. This appliance is equipped with an ignition
device which automatically lights the burner.
Do not try to light the burner by hand.
you smell gas STOP! Follow "B" in the safety
information above on this label.
If you don't smell gas, go to next step.
valve on the domestic cold water inlet pipe.
8. Turn on the electricity supply to the boiler,
switching on the circuit breaker. The appliance
1
Figure 1
service is to be performed.
RIVA ADVANCE COMBI MANUAL
OPERATING INSTRUCTIONS
2 1 3
TO TURN OFF GAS TO APPLIANCE
--- If you cannot reach your gas supplier, call the
C Use only your hand to push in or turn the gas
control knob.
Never use tools. If the knob will not push in or
turn by hand, don't try to repair it, call a
or explosion.
D Do not use this appliance if any part has been
service technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been under water.
seconds (stand---by condition).
9. If the boiler is to be used for c.h and d.h.w
position th
2 seconds (operating boiler).
Position the knobs 2 and 3 for the desired c.h.
and d.h.w. temperature (for detailed
information see the user manual).
10.If the boiler is to be used for d.h.w. only
2 seconds (operating boiler).
Position the knob 3 for the desired d.h.w.
temperature (for detailed information see the
user manual).
11.If the appliance will not operate, follow the
i
call your service technician or gas supplier.
2 1
Figure 2
3. Set the thermostat or other operating control
to lowest setting
valve on the domestic cold water inlet
pipe.
3 2
Figure 3
1
42