Resetting The Zyair; Method Of Restoring Factory-Defaults; Figure 8 Change Password Screen - ZyXEL Communications ZyAIR G-3000 User Manual

ZyAIR G-3000 User's Guide

Figure 8 Change Password Screen

You should now see the MAIN MENU screen..

2.2 Resetting the ZyAIR

If you forget your password or cannot access the ZyAIR, you will need to reload the factory-
default configuration file or use the RESET button on the top panel of the ZyAIR. Uploading
this configuration file replaces the current configuration file with the factory-default
configuration file. This means that you will lose all configurations that you had previously.
The password will be reset to "1234", also.

2.2.1 Method of Restoring Factory-Defaults

You can erase the current configuration and restore factory defaults in three ways:
Use the RESET button on the side panel of the ZyAIR to upload the default configuration file
(hold this button in for about 10 seconds or until the SYS LED, LINK LED or BRI/RPT LED
turns red). Use this method for cases when the password or IP address of the ZyAIR is not
known.
Use the web configurator to restore defaults (refer to the Maintenance chapter).
Transfer the configuration file to your ZyAIR using FTP. See later in the part on SMT
configuration for more information.
39
Note: The management session automatically times out when
the time period set in the Administrator Inactivity Timer field
expires (default five minutes). Simply log back into the ZyAIR if
this happens to you.
Chapter 2 Introducing the Web Configurator