Selecting The Probe Type - GE Moisture Target Series 6 User Manual

3.6.10 Selecting the Probe Type

Use the following procedure to select the probe type.
Note:
Changing the probe setting will default the output and alarm
IMPORTANT:
settings to DPC. Also, the default fault trip point values will be
set along with the default output range values.
Moisture Target Series 6 Hygrometer User's Manual
Chapter 3. Operation and Programming
From the Settings Menu select Probes and
press Enter
. The following screen
appears.
To access the Probes menu, the User
Note:
Passcode is required (see section 3.6.1 on
page 56).
Use the left and right arrow keys to select
each digit to be changed and the up and
down arrow keys to increase or decrease its
value. Once the passcode has been entered,
press Enter
appears.
Use the left or right arrow key to select the
correct probe type and press Enter
MTS6 reboots in 5 seconds.
and the following screen
. The
73