GE Moisture Target Series 6 User Manual page 42

Chapter 2. Installation
2.6.6 Installing the DC Power Cable (cont.)
Strip each conductor of the DC power cable by approximately 3/8".
2.
Insert each wire into the appropriate slot (+, – and chassis) and tighten
3.
each screw to secure them in place.
Ensure that the chassis ground connection is properly
IMPORTANT:
grounded.
Reinsert the DC connector into the rear panel (see Figure 42).
4.
32
[no content intended for this page]
Figure 42: Reinserting the DC Connector
Moisture Target Series 6 Hygrometer User's Manual