Chapter 3. Operation And Programming; Using The Mts6; Starting Up - GE Moisture Target Series 6 User Manual

Chapter 3. Operation and Programming

3.1 Using the MTS6

3.1.1 Starting Up

After proper installation, the MTS6 Transmitter can be set up to
accommodate the user's requirements. Typically, the user may need to
configure the analog outputs, trim the analog outputs, and program logging.
Refer to a Menu Map, Figure 49 on page 94 when using an M Series probe,
or Figure 50 on page 95 when using a VeriDri probe, and complete the
following steps. Upon startup, the MTS6 proceeds through several displays
until a screen similar to the following appears:
In most instances; use the Enter key to save an entry and/or move
Note:
ahead to the following screen; use the Cancel key to reject an entry
and/or return to the previous screen.
Moisture Target Series 6 Hygrometer User's Manual
Chapter 3. Operation and Programming
After startup, the screen will need to be
unlocked. To unlock the screen, press
Cancel, Enter, Cancel.
33